NEW & USED MACHINERY
Machinery and Systems for the Architectural,
Woodworking, & Composite Panel Industries


The process temperature control specialists
///[ Product Range: 3 kW - 150 kW heating capacity ]///

TT-188: TEMPERATURE CONTROL UNIT
      The TT-188 is a small, but powerful temperature control unit for use with water temperatures up to 200 °F/ 90 °C and mold weights up to 1,300 lbs/ 600 kg.   The TT-188 can also be used with thermal oil at a maximum temperature of 300 °F/ 150 °C and a maximum mold weight of 650 lbs/ 300 kg.  All Tool-Temp temperature control units and water chillers are fitted with the self-optimizing microprocessor controller MP-888 (pictured above.)  The self-optimizing feature allows a very high regulating accuracy even at high temperatures and adheres to the set temperature independently of the consumer.


TT-188
Powerful small temperature control unit with electronic flow control
Operational use: With water up to 90°C, moulds up to 600 kg
With oil up to 150°C, moulds up to 300 kg
Technical data:
Heating capacity: 9 kW water with operation, for oil operation
Cooling capacity: 18 kW at 90°C
Pump capacity: Motor 0,75 kW, max. 4,5 bar / max. 75 l/min
Dimensions: Length: 670 x Width: 260 x Height: 650 mm
Weight: approx. 55 kg (empty)
Special features:
Digital flow indication: Indication of flow rate in litres and gallons and control of the minimum flow. As soon as the flow falls below a minimum, the alarm is activated.
Lime scale free heat exchanger: The lime scale free heat exchanger is a special construction made of stainless steel
Leakstopper device and mould drain Unit can be used in pressure or vacuum mode
All components in contact with water are made of stainless steel. Pump made of bronze, Quality is equivalent to V2A.






Included Features

  • MP-888 microprocessor controller
  • Automatic temperature control that activates alarm when the actual temp deviates 5+ °C from the set temp
  • Automatic aeration / venting
  • Automatic water refill
  • Automatic mold drain
  • Switchable stages for varied heating capacities (3 kW oil operation to 9 kW water operation)
  • Highly audible alarm system
  • Leak stopper- operates in pressure or vacuum mode to allow continuous production despite leakage from mold or connections
  • Limescale-free heat exchanger
  • Corrosion-free unit.  All components in contact with water are made of stainless steel or bronze.
  • Castors
  • Safety Devices:

    - Level control provides auto dry run protection

    - Separate mechanical safety thermostat

    - Temperature limiter installed in the controller

    - Motor protection switch, transformer, insulation


< back to Tool-Temp Products page >


Content copyright 2021. Joos USA. All rights reserved.